Quick answer: tune each string one semitone lower than standard: E♭ A♭ D♭ G♭ B♭ E♭, from the thickest string to the thinnest. Use a tuner set to “half step down” or chromatic, tune each string up to its note from slightly below, then check them all again, because the neck settles as the tension drops.
The notes and frequencies
With the standard reference of A4 = 440 Hz:
| String | Standard | Half step down | Frequency |
|---|---|---|---|
| 6 (thickest) | E | E♭ | 77.78 Hz |
| 5 | A | A♭ | 103.83 Hz |
| 4 | D | D♭ | 138.59 Hz |
| 3 | G | G♭ | 185.00 Hz |
| 2 | B | B♭ | 233.08 Hz |
| 1 (thinnest) | E | E♭ | 311.13 Hz |
Each one is about 6% lower in frequency than its standard note, which is what one semitone is.
Tune down with a tuner
- Open a tuner. Our free online tuner has a Half step down setting; any chromatic tuner works too.
- Start with the 6th string. Lower it until the tuner shows E♭, go a touch below, then tune back up to it. Tuning up to the note helps the string hold.
- Repeat for A♭, D♭, G♭, B♭ and E♭.
- Go round once more. Lowering six strings changes the pull on the neck, so the first ones you tuned will have drifted.
Playing a half-step-down song on ukulele? Lower each string a semitone to G♭ B E♭ A♭ using chromatic mode, or start from how to tune a ukulele if you’re not yet in standard tuning. On bass, the same song means E♭ A♭ D♭ G♭; how to tune a bass guitar covers the notes and the by-ear method.
Tune down by ear
If you only have a reference for the low string, tune that to E♭, then use the usual 5th-fret method: the 5th fret of each string matches the next open string, except the G string, where the 4th fret matches the open B♭ string. The intervals are identical to standard tuning (E A D G B E); only the starting point moves. For the harmonics method and how to hear when two strings match, see how to tune a guitar by ear. (If you only need the low string lower, that’s drop D tuning instead; for slide and Rolling Stones-style riffs it’s open G tuning.)
Skip the retune: change the song’s key instead
Tuning down for one song and back up for the next is slow at a gig or in a lesson. If the song you’re learning is recorded in half step down, you can raise the recording by one semitone instead and play along in standard tuning with your usual shapes. Not sure it’s a full half step? Measure how far off the recording is first.
The reverse works as well: drop a standard-tuned song a semitone to play along in E♭ tuning. See how to change the key of a song.
Which should you use?
| Your situation | Do this |
|---|---|
| A whole set or album in E♭ | Retune the guitar half a step down |
| One song in a set of standard-tuned songs | Raise the recording a semitone instead |
| Singing, and the song is a bit too high | Tuning down lowers your chords one semitone; or lower the recording |
| You keep drifting out of tune | Heavier strings hold low tunings better |
Lower tunings are slacker, so you may notice a little more buzz. That’s normal; a slightly heavier string gauge fixes it if it bothers you.