Quick answer: standard bass tuning is E A D G, from the thickest string to the thinnest. Open a tuner (our free online tuner has a Bass · Standard setting), pluck each string and turn its tuning key until it reads E, A, D and G. With no tuner, get one string right from a reference, then press each string at the 5th fret and match it to the next open string.
The notes and frequencies
A bass is tuned to the same notes as the four lowest guitar strings, one octave down. With the standard reference of A4 = 440 Hz:
| String | Note | Frequency | Guitar string with the same name |
|---|---|---|---|
| 4 (thickest) | E1 | 41.20 Hz | Low E (E2, 82.41 Hz) |
| 3 | A1 | 55.00 Hz | A (A2, 110.00 Hz) |
| 2 | D2 | 73.42 Hz | D (D3, 146.83 Hz) |
| 1 (thinnest) | G2 | 98.00 Hz | G (G3, 196.00 Hz) |
| Low B (5-string only) | B0 | 30.87 Hz | — |
Those low frequencies are why tuning a bass trips people up. A guitar tuner app works fine, but the microphone has to hear a note that’s barely above the bottom of human hearing.
Tune a bass with a tuner
- Open a tuner. In the browser, use the online tuner and choose Bass · Standard. A clip-on tuner or any chromatic tuner works too.
- Pluck the E string firmly and let it ring. Hold the phone close to the bass’s body, or to the amp speaker if you’re plugged in.
- If it reads flat (below E), tighten the tuning key. If it reads sharp, loosen it a little below E, then tighten back up to it. Tuning up to the note helps it hold.
- Repeat for A, D and G.
- Go round once more. Changing one string pulls on the neck a little, so the first ones can drift.
If the tuner won’t settle on the E string, play its harmonic instead: rest a fingertip lightly on the string directly over the 12th fret (don’t press it down) and pluck. You get E2, an octave higher, which any tuner reads easily, and tuning the harmonic tunes the open string.
Tune a bass by ear (5th-fret method)
This tunes the bass to itself, so get the E string right first from a piano, a keyboard app or a tuned guitar (the guitar’s low E is the same note an octave up).
- A string: press the E string at the 5th fret. That’s A1; match the open A string to it.
- D string: press the A string at the 5th fret. That’s D2; match the open D string.
- G string: press the D string at the 5th fret. That’s G2; match the open G string.
- Play a few notes across the strings. Octaves (E string 2nd fret with the D string 4th fret, for example) should sound clean, not sour.
When two notes are close but not matched, you’ll hear a slow wobble. Keep making small turns until it stops. On a bass the wobble is slow and easy to hear, which makes this method more reliable than it is on guitar.
Tune with harmonics
Harmonics ring on while you turn the key, so both hands are free. Touch the string lightly over the fret, don’t press:
| Touch this harmonic | Matches this harmonic | Note |
|---|---|---|
| E string, 5th fret | A string, 7th fret | E3 |
| A string, 5th fret | D string, 7th fret | A3 |
| D string, 5th fret | G string, 7th fret | D4 |
| Low B, 5th fret (5-string) | E string, 7th fret | B2 |
One honest caveat: a 7th-fret harmonic is a pure fifth, which is about 2 cents sharp of the equal-tempered note the frets play. Each step adds about 2 cents, so the last string tuned can end up around 6 cents off. Use harmonics to get close, then check against a tuner or the 5th-fret method.
5-string bass and other tunings
| Bass | Notes (thick to thin) | How to tune the odd string |
|---|---|---|
| 4-string standard | E A D G | As above |
| 5-string | B E A D G | B string at the 5th fret = open E |
| Drop D | D A D G | Lower the E a whole step; its 12th-fret harmonic matches the open D string |
| Half step down | E♭ A♭ D♭ G♭ | Every string one semitone lower, as on guitar (half step down guide) |
The low B (30.87 Hz) and a dropped D (36.71 Hz) are below what most microphone tuners can detect, including ours, which listens down to 40 Hz. Tune those strings by the fretted or harmonic match in the table, or with a clip-on tuner. The same idea as guitar drop D tuning applies: only the lowest string changes.
Playing along with a song
Once you’re in tune, the hard part is hearing the bass line. It sits low in the mix and moves fast. Free first: YouTube’s speed setting slows a video down without changing the key (see how to slow down a song without changing the pitch), and if a recording is in a different tuning from yours, you can find its key and move the notes. What YouTube won’t do is repeat one tricky bar for you, over and over, at half speed.
This works with your own audio files, voice memos and purchased songs. Streaming songs from Apple Music or Spotify are protected, and no app can open them.
Which method should you use?
| Your situation | Do this |
|---|---|
| You have a phone or computer | Tuner in Bass mode; use the 12th-fret harmonic if the E won’t register |
| No tuner, playing alone | 5th-fret method from any E reference |
| Playing with a band | Tune to a tuner or the guitarist’s tuned low E, not to yourself |
| 5-string low B or drop D | Fretted or harmonic match to the E or D string, or a clip-on tuner |
| Strings won’t hold pitch | New strings stretch for a few days; retune upward each time |